Archive Home arrow Reviews: arrow Storage arrow OCZ Vertex-2 Extended Solid State Drive
OCZ Vertex-2 Extended Solid State Drive E-mail
Reviews - Featured Reviews: Storage
Written by Olin Coles   
Thursday, 08 July 2010
Table of Contents: Page Index
OCZ Vertex-2 Extended Solid State Drive
Features and Specifications
Closer Look: OCZ Vertex 2 Extended
SandForce SF-1200 SSD Controller
SSD Testing Methodology
AS-SSD Benchmark
ATTO Disk Benchmark
CrystalDiskMark 3.0 Tests
Iometer IOPS Performance
EVEREST Disk Benchmark
HDD vs Hybrid Drive vs SSD
OCZ Vertex 2 Extended Conclusion

EVEREST Disk Benchmark

Many enthusiasts are familiar with the Lavalys EVEREST benchmark suite, but very few are aware of the Disk Benchmark tool available inside the program. The EVEREST Disk Benchmark performs linear read and write bandwidth tests on each drive, and can be configured to use file chunk sizes up to 1MB (which speeds up testing and minimizes jitter in the waveform). Because of the full sector-by-sector nature of linear testing, Benchmark Reviews endorses this method for testing SSD products, as detailed in our Solid State Drive Benchmark Performance Testing article. However, Hard Disk Drive products suffer a lower average bandwidth as the capacity draws linear read/write speed down into the inner-portion of the disk platter. EVEREST Disk Benchmark does not require a partition to be present for testing, so all of our benchmarks are completed prior to drive formatting.

The high-performance storage products tested with EVEREST Disk Benchmark are connected to the Intel ICH10 controller on the Gigabyte GA-X58A-UD7 motherboard. Using the 1MB block size, read performance of the OCZ Vertex 2 Extended SSD measured an average 264.0 MBps with a nearly identical maximum peak of 267.1 MBps. Linear write-to tests were next...

Everest-Read_OCZ-Vertex-2-OCZSSD2-2VTXE120G.png

Linear disk benchmarks are superior bandwidth speed tools in my opinion, because they scan from the first physical sector to the last. A side affect of many linear write-performance test tools is that the data is erased as it writes to every sector on the drive. Normally this isn't an issue, but it has been shown that partition table alignment will occasionally play a role in overall SSD performance (HDDs don't suffer this problem).

The waveform chart below illustrates how the integrated buffer manages file transfers, and makes linear write performance appears relatively even. The results seen here are still relatively consistent compared to most other SSD products we've tested in the past. The OCZ Vertex 2 SSD recorded an average linear write-to speed of 259.2 MBps, with a maximum performance of 261.3 MBps.

Everest-Write_OCZ-Vertex-2-OCZSSD2-2VTXE120G.png

The chart below shows the average linear read and write bandwidth speeds for a cross-section of SATA storage devices tested with EVEREST:

EVEREST-Disk-Benchmark_Results.png

Linear tests are an important tool for comparing bandwidth speed between storage products - although HDD products suffer performance degradation over the span of their areal storage capacity. Linear bandwidth certainly benefits the Solid State Drive, since there's very little fluctuation in transfer speed. This is because Hard Disk Drive products decline in performance as the spindle reaches the inner-most sectors on the magnetic platter, away from the fast outer edge.

Drive Hardware

In the next section, I share my final thoughts on the struggle between SSD and HDD technology before delivering my conclusion and final product rating.



 

Comments 

 
# RE: OCZ Vertex 2 Extended Solid State DriveRobert17 2010-07-14 02:45
Recently I had checked back on a year-old SSD review, the Kingston Now V series, then a another older SSD review on a Patriot. And I note a lead article regarding suggested benchmarking specs via SNIA. Only a couple of years into SSDs and the offerings are remarkably better. And of course Intel is going to sharpen the point of the stick by year-end with 25nm flash memory for their newest products. This is without doubt the most rapidly advancing technology for PCs that I can recall. The next five years should be interesting. Looking back from that perspective should be even more eye-popping.
Report Comment
 
 
# RE: OCZ Vertex 2 Extended Solid State DriveJeff C 2010-07-14 11:01
On the chart showing the Intel controller, I think the garbage collection exists for it. I have the M25-V, and it has both a GC tool and has TRIM support.
Report Comment
 
 
# Only the latest SSDsOlin Coles 2010-07-14 11:36
Only second-generation Intel SSDs with the latest firmware revision support TRIM and garbage collection (X25-M G2). The other 90% of the SSDs they've sold do not. I will update that chart so future articles will specify support on G2.
Report Comment
 
 
# C300 results wrong!?Thomas Bruckschlegel 2010-07-15 11:42
I cannot repro your results, I get ~ 10000 IOPS with your settings: 100% random, 50% write, 50% read, 4KB, 32 outstanding I/O's per target - using the SATA2 interface on my P55 based board.

BTW. iometer is highly affected by compression - I have no troubles reaching ~45000 IOPS with my older Indilinx based SSD on a compressed NTFS partition.

Thomas
Report Comment
 
 
# RE: C300 results wrong!?Olin Coles 2010-07-15 11:52
Hello Mr. Bruckschlegel:

I will email you my Iometer configuration file, so that you may reproduce our test exactly as we conduct it. Please be informed that all SSDs are wiped clean using DISKPART "clean all" prior to testing. Also note that this is the total IOPS reported by the test, and not an individual read or write.
Report Comment
 
 
# RE: C300 results wrong!?Olin Coles 2010-07-15 16:40
There's a major difference between the Marvell SATA-6G controller and the Intel ICH10 on your P55 motherboard. While the Intel ICH10 will likely provide better IOPS results, it won't offer 6.00 GB/s connectivity or speeds. Crucial sent a Marvell controller with the SSD, so our tests have all used their 'recommended' setup.
Report Comment
 
 
# RE: RE: C300 results wrong!?Thomas Bruckschlegel 2010-07-15 19:17
I tried your file, I had an error in mine "Align I/Os on" was set to "sector boundaries" instead of "4KB" - now I get 20220 total I/Os per second.

Do you think this is totally controller related?
BTW, sanity erase or a format of the whole drive (not a quick format) under win7 with a TRIM enabled AHCI driver+controller will restore the factory performance, not sure if a "diskpart clean all" will do the same.

Thomas
Report Comment
 
 
# RE: OCZ Vertex-2 Extended Solid State DriveJayson 2010-10-02 10:29
On the ICH10R tests are you using the Intel driver or Microsoft driver? Should probably clarrify as you can be using the Intel controller with either driver set.
Report Comment
 
 
# RE: RE: OCZ Vertex-2 Extended Solid State DriveOlin Coles 2010-10-02 10:32
The article already specifies that the Intel RST driver is used, and the tests show the iaStor driver.
Report Comment
 
 
# MTTF and MTBF are not the same thingTypoknig 2011-01-03 15:56
Hi Olin, I noticed on your specs page that you listed the this SSDs MTTF as 200,000,000 hours, but everywhere I look OCZ has only published the MTBF numbers. Maybe a typo on your end? This number jumped right out at me because I was surprised to see that this drives MTBF numbers have increased from the 1,500,000 hours MTBF spec of the original 120GB Vertex drives. If you have any inside contacts with OCZ I would very much like to know how they are calculating this number. Of the three original 120GB Vertex drives I purchased in June of 2009 all have failed (at different times), were replaced via RMA, and then proceeded to fail again. In total I have had 7 of the original 120GB Vertex drives in my position, and one just failed again two days ago. Seems to me that OCZ's MTBF numbers are off (and all the failures mentioned by people in various forums seems to support that notion). I should point out though that OCZ has always processed my RMA hassle free, and they are now working with me to take my original drives that I have had so much trouble with and upgrade me to something a bit more stable. I really appreciate them standing by their product, and I hope they can work out the kinks in their line of SSD products soon.
Report Comment
 
 
# RE: MTTF and MTBF are not the same thingOlin Coles 2011-01-03 15:59
Hello:

Thank you for bringing this to our attention. These specification are pulled directly from the manufacturer-supplied data sheet, and are often subject to change without notice. I would consider the specifications listed on the website to be the most current and accurate.
Report Comment
 

Comments have been disabled by the administrator.

Search Benchmark Reviews
QNAP Network Storage Servers

Follow Benchmark Reviews on FacebookReceive Tweets from Benchmark Reviews on Twitter