Archive Home arrow Reviews: arrow Video Cards arrow XFX Radeon HD5750 Video Card HD-575X-ZNF7

XFX Radeon HD5750 Video Card HD-575X-ZNF7 E-mail
Reviews - Featured Reviews: Video Cards
Written by Bruce Normann   
Wednesday, 21 October 2009
Table of Contents: Page Index
XFX Radeon HD5750 Video Card HD-575X-ZNF7
XFX Radeon HD5750 Features
Radeon HD5750 Specifications
Closer Look: XFX Radeon HD 5750
XFX Radeon HD5750 Detailed Features
ATI Eyefinity Multi-Monitors
Video Card Testing Methodology
3DMark Vantage Benchmarks
Crysis Benchmark Results
Devil May Cry 4 Benchmark
Far Cry 2 Benchmarks
Resident Evil 5 Benchmarks
World in Conflict Benchmarks
BattleForge - Renegade Benchmarks
XFX Radeon HD5750 Temperature
VGA Power Consumption
Radeon HD5750 Final Thoughts
XFX Radeon HD5750 Conclusion

XFX Radeon HD5750 Detailed Features

The main attraction of ATI's new line of video cards is the brand new GPU with its 40nm transistors and an improved architecture. The chip in the 5700 series is called "Juniper" and is essentially half of the "Cypress", the high-end chip in the HD5800 series that was introduced in September, 2009.


The Juniper die is very small, as can be seen with this comparison to a well known dimensional standard. ATI still managed to cram over a billion transistors on there, and the small size is critical to the pricing strategy that ATI is pursuing with these new releases.

1 GB of GDDR5 memory, on a 128-bit bus with a 4.6 Gbps memory interface offers a maximum memory bandwidth of up to 73.6 GB/sec. Cutting the Cypress GPU in half limited the bus to 128-bit, but ATI has bumped up the clock rate on all their new boards. With GDDR5 running at 1150 MHz, the memory itself won't be a bottleneck on this card, but the narrower bus width does have a major performance impact. There is some room for memory overclocking via the Overdrive tool distributed by AMD.


The H5GQ1H24AFR-T2C chip from Hynix is rated for 5.0 Gbps, and is one of the higher rated chips in the series, as you can see in the table below. An overclock to the 1250-1300 MHz range is not unthinkable, especially if utilities become available to modify memory voltage.


The power section provides 3-phase power to the GPU; that's about average for a mid-range graphics card, and while increasing the number of power phases achieves better voltage regulation, improves efficiency, and reduces heat, ATI has used the inherently lower power requirements of the Juniper GPU and some fancy footwork in the power supply control chip to reduce power draw to very low levels. The fact that the GPU on the 5750 has 10% of the available Stream Processors disabled and runs 18% slower than the 5770 also helps.


Where the HD5800 series used a number of Volterra regulators and controllers, the HD5750 makes do with one uP6209AQ controller chip from uPI. It's a relatively simple controller compared to the units on the HD5770 and the 58xx series. The combination of a lower power GPU and low power GDDR5 memory however, yields an incredibly low power consumption of 16W at idle and 86W under duress. Another cost-cutting measure can be seen here, the use of standard electrolytic capacitors in a few locations.


The assembly quality on the XFX Radeon HD5750 PCB is up to the levels I expect to see on a high-end retail product like this. The image above is from the back side of the printed circuit board, directly below the GPU. It is one of the most crowded portions of the PCB, and one where any small misplacement of a component can have serious implication on stability, especially for overclocking. Before we dive into the testing portion of the review, let's look at one of the most exciting new features available on every Radeon HD5xxx series product, EyeFinity.


Comments have been disabled by the administrator.

Search Benchmark Reviews

Like Benchmark Reviews on FacebookFollow Benchmark Reviews on Twitter